43
Message Displayed
Probable Cause/Event
Corrective/User Action
Front/Rear bumper
pressed
CAUTION – DO
NOT
attempt to
disable this safety
device in the event
you are unable to
isolate and correct
the problem. Contact
your service provider
for repair before
using.
-
Front or Rear Bumper is constantly being pressed
-
Move mower away from object pressing
against bumper.
CAUTION
– Remove power pack before lifting
the mower
-
The Robomow has driven onto an obstacle,
raising the front end. Remove or exclude this
object from the mowing area.
-
The Robomow is being used on a slope too
steep for safe mowing. Exclude this from the
mowing area.
-
High grass is preventing the front wheel from
fully riding on the ground. Raise the cutting
height.
Front Wheel
Problem
CAUTION – DO
NOT
attempt to
disable this safety
device in the event
you are unable to
isolate and correct
the problem. Contact
your service provider
for repair before
using.
-
The Front Wheel has left the ground for more than
8 – 10 seconds.
-
The ground contains large holes or indentions
where the front wheel can drop into when
passing across. Fill these areas with dirt and
level off.
High temp.
Disc. charger
-
Robomow is charged through the plug and
ambience temperature is out of range (above
158ºF / 70ºC)
-
Robomow charging is not allowed when the
ambience temperature is raised above 158ºF /
70ºC; Disconnect the charger plug and wait
until the temperature will go down or take the
Robomow to be charged in a cooler place.
Keep charging if not
used
-
Message is displayed every time the charger plug
is disconnected from the mower.
-
Displayed when the mower isn’t in operation and
not connected to the charger/Docking Station for a
long time.
-
Press any key to change the display back.
-
Send the mower back to the Docking Station
for charging / connect the charging plug or
continue in operation
Keys locked
-
Child lock feature has been activated
-
Press the
Up
⇑
arrow key and then press the
‘C’
button. Child lock can be deactivated under
User preferences
.
Low temp.
Disc. charger
-
Robomow is charged through the plug and
ambience temperature is out of range (below 32 ºF
/ 0 ºC); disconnect the charger plug from the
Robomower.
-
Robomow charging is not allowed when the
ambience temperature is going down below
32ºF / 0ºC; Disconnect the charger plug and
wait until the temperature will go down or take
the Robomow to be charged in a warmer
place.
Move from Wire
-
The Robomow is positioned too close or on top of
the perimeter wire
-
Move the Robomow approximately 6 – 10 feet
(1.5 – 3m) away from the perimeter wire and
start again.
Mowing Overload
Cooling, Wait
-
The mowing motors have been working under a
severe load for too long of a time.
-
Wait until the message ‘
Mowing Overload –
Press GO’
is displayed.
No Wire Signal
-
Perimeter Switch is not turned on or not connected
to the zone intended to mow
-
Make sure the Perimeter Switch is connected
to the correct zone and is turned on
Rain
GO for override
-
Robomow detects rain upon GO pressing
-
Do not operate Robomow in rainy weather and
wet grass; If you chose to override press the
GO button; The overriding is valid for the
current operation only
Ready
Keep Charging
-
The battery is fully charged
-
Keep the charger (power supply) connected
and operating
