OPERATION Cont.
Energy Tips:
In Cool mode, when the Water Injection indicator lights up [ ], you may
•
inject some water through the injection port before cooling begins (do not
overfill) to add humidity to the air.
In Dehumidifying Mode
•
[ ],
the water must be drained periodically,
otherwise, the unit will turn off when the water level exceeds the maximum
capacity.
Do not use the air exhaust duct when in Dehumidify or Fan modes
•
[ ].
If the room is directly exposed to sun, draw the curtains for better efficiency.
•
Cooling mode
Turn on:
1.
Press the Power button to turn the unit on [ ].
Select Cool mode:
2.
Press Mode button until the Cool Mode Indicator
light is on [ ] or press the Cool Mode button on the remote control.
Adjust temperature:
3.
Press Up [ ] or Down [ ] button to set the
desired room temperature. The range is 64-84°F (18-29°C).
Adjust Fan speed:
4.
Select the desired fan speed by pressing the fan
button [ ] on the unit or by selecting Low [ ], Medium [ ] or
High [ ] on the remote control.
Set Swing (or oscillation):
5.
Press Swing button [ ] to adjust the
direction of the vertical vent. Press this button once to set the vertical vent
to swing automatically. Press it again to make it stop. (Adjust the horizontal
vent by hand.)
OPTIONAL ENERGy SAVING COOL mODE:
6.
This unit also has an
Economy Mode to help save energy. This is only available in Cool Mode.
To select this mode press the economy mode button on the unit or the
remote [ ]. The Cool Mode indicator will blink [ ] to show that the unit
is running in Economy Mode. The temperature will automatically switch to
81°F and a low fan speed. These settings can not be changed. To cancel
this mode, press the Economy Mode button again.
OPERATION CONTINUED on page 13
9
12
INSTALLATION
ATTENTION: This length has been designed according to the
specifications of the air conditioner. Do not use an extension or
exchange of a different hose as that may lead to a malfunction.
Energy tip!
The length of the air exhaust duct can expand up to 5ft; but
the shorter the exhaust duct is kept, the more efficiently the unit will work.
Window Kit Installation
The window kit is designed to fit most standard vertical and horizontal windows. However, it may be necessary to
modify some aspects of the installation procedures for certain types of windows. Please refer to the illustrations.
To prepare your window for installation, take the thin strips of self-stick foam and peel off the adhesive liner
on one side only. apply them around the window sill where the window slider will be placed. next, peel off the
remaining adhesive liner and apply the thick foam to this.
Fit the window slider adapter securely within the window, sliding it open until it completely fills the width of the
window. (OPTIOnal: you may also use the included screw to secure the slider to the window.) close the window
firmly. attach the window exhaust adapter to the end of the exhaust hose then snap it into the slider.
Placement
Place the unit in a flat, dry place. leave
at least 1 ½ ft. of space around the unit
(when the hose is not connected).
AIR Exhaust Duct mounting method
1) attach the square end of the exhaust duct to the exhaust
terminal of the unit.
2) attach the other end (outflow) to the nearest window.
leave at least 1 ½ ft. of space around the unit.
