6
15
CONTROL PANEL
ATTENTION:
If the unit is turned off in cool or Dehumidify mode and restarted immediately, then the air
conditioner will wait at least 3 minutes before running again.
Buttons
1.
Timer:
Press to set timer. Use the up and down arrows to set time. see Page 11 for more info.
Swing:
Press to make the vertical vent swing automatically. Press again to stop.
Speed:
Press for 2 seconds to select high, medium or low fan speed.
Up/down:
Press the up or down button to set the temperature. In Timer Mode, this adjusts the
time. Press both buttons at the same time to switch between celsius and Fahrenheit.
mode:
Press this button to select cool, dehumidify or fan mode.
Economy mode:
Press for the energy saving mode (cool mode only). The in the leD
display will blink indicating the economy mode is selected. The temperature will automatically switch to
81˚F and a low fan speed. These settings can not be changed. To cancel, press this button again.
Power:
Press this button to turn the unit on/off.
LED display
2.
Timer
Dehumidify, Cool, and Fan Modes
Water Injection indicator
Water Full indicator
Remote Control sensor
High, Medium and Low fan speeds
Indicates time and temperature.
also displays error codes.
In case of malfunction, refer to the Troubleshooting Guide in this manual.
Indicates Celsius or Fahrenheit degrees.
C F
Mode
mAINTENANCE
Cleaning
ATTENTION:
Turn off the unit and pull the plug out before any cleaning.
Energy Tip!
Dust in the air filter will reduce efficiency. Clean the filter every
2-4 weeks for better performance.
Cleaning the surface
Clean the surface of the unit with a duster or a damp soft cloth. Do not use a
chemical solvent like benzene, alcohol, gasoline, etc. as it may damage or even
deform the unit.
Cleaning the air filter
Pull out the air filters (2).
1.
Wash the air filters by immersing them gently into
2.
warm water (under 104°F or 40°C) with a mild soap.
Use a soft, lint-free cloth.
Rinse the filters thoroughly and let them dry
3.
completely in an area out of direct sunlight.
Push the air filters back into their original positions.
4.
End of season
Switch off the unit and disconnect the plug from the power supply.
1.
Pull the plug from the drain mouth and remove the water from the basin. You
2.
can remove the water entirely by carefully tilting the unit back.
Clean the air filters. Let them dry completely before inserting them back in the
3.
ArcticPro.
Run the unit in Fan Mode on the low setting for half a day to dry the inside and
4.
prevent mildew.
Wrap the cord around the cord storage on the back of the unit.
5.
Remove the air exhaust duct and store it in a dry and safe place.
6.
Wrap the unit with a plastic bag and keep, with all accessories, in a dry place.
7.
Take the batteries out of the remote control before storage.
8.