SERVICE PROCEDURES
Page 19
Page 19
Service Manual Bake Star intelligent
PKII
form 9123665 rev. 06/2013
As mentioned before, the hinge and outer
glass are glued together with tape. All
other strips and posts on the inner and
outer glass are screwed.
It is very important that metal parts do not
touch the glass. In case it does touch, the
glass will burst eventually!!!.
Take care that during mounting a new glass,
that no splinter of the old glass remains
between the post and the new glass. Also
then, the new glass will burst.
Nowadays the glass is clamped in between
2 ptfe flanged bushes. The “bush part”
which goes into the hole in the glass,
is 2mm or 3mm high. By placing such a
flange bush on either side, the hole has to
be filled up completely.
The inner glass is 5mm thick. See Note! The-
refore a 2mm and a 3mm bush is used in
each hole.
The outer glass is 6mm thick. There, two bu-
shes of 3mm will be used in each hole.
At the same time, thick washers are used un-
der the different bolt heads and nuts.
6mm
5mm
Outer glass
Inner glass
2x
3mm bush
1x 3mm bush
1x 2mm bush
MOUNTING OF THE GLASS
Note!!!!
The BS10 units from serial number 100054521
(week 36 2011) have inner glass of 6mm
thickness. These need to be mounted with
3 mm bushes on both sides.
Summary of Contents for BS10i
Page 85: ...ELECTRICAL DIAGRAMS Page 85 Service Manual Bake Star intelligentPKII form 9123665 rev 06 2013...
Page 86: ...ELECTRICAL DIAGRAMS Page 86 Service Manual Bake Star intelligentPKII form 9123665 rev 06 2013...
Page 87: ...ELECTRICAL DIAGRAMS Page 87 Service Manual Bake Star intelligentPKII form 9123665 rev 06 2013...
