995367 – Revision A
Page 30 of 39
Step 9 - From the Leg Actuator Cover, remove the plastic nut on the inside that secures the
cable to allow the Cable to pass through the hole. A 16mm Spanner may be required to
assist.
Step 10 – Pull the Cable through to fully remove detach the Leg Actuator Cable and the Leg
Actuator Cover from the Hoist.
Refitting / Replacement
Step 11 - Refitting is a reversal of the removal process noting the following point:
A)
Pull the Leg Actuator Cable through the Leg Actuator Cover and place the
connectors through the black nut. Secure the Cable by threading the nut onto the
white plastic thread that is placed on the cable.
B)
When attaching the fixing the cables. Ensure the Red and Brown are connected
together, and the Green and Blue. DO NOT circuit these cables incorrectly.
C)
When fixing the Leg Actuator Cover to the Base, ensure to place a small washer on
either side of the Cover. The process should be: screw, washer, and cover, base
fixing point, washer and nut.
