995367 – Revision A
Page 23 of 39
9.6 – Leg Actuator
Within this section it will explain the correct procedure on removing and reinstalling the Leg
Actuator for servicing procedures or replacement.
Removal
Step 1 – Remove the Leg Actuator Cable. (Refer to section 9.2.3)
Step 2 – Follow steps 1-4 from section 9.12 (Base Removal) to detach the Mast and Base
correctly.
Step 3 – Remove the Leg Actuator Cover. (Refer to section 9.8)
Step 4 – Place the Base on its side for easier service access.
Step 5 – Using Long Nose Pliers, bend the two retaining ends of the retaining clip forward to
straighten them to allow removal.
Step 6 – Grab the retaining clip from the looped end and pull the clip out of the pin as
shown.
