6
DEMO9S08QE8 User Manual
into your computer’s CD-ROM drive. A start-up window will automatically
appear. Select CodeWarrior Installation and follow the on-screen instructions.
3.3.2
Installing P&E Resources
Use the DEMOQE Resources CD-ROM to access and install P&E resources
for the DEMO9S08QE8. These materials are not required for operation. The
support materials contained on the DEMOQE Resources CD-ROM are listed
in
Section 1.4 - Recommended Materials On DEMOQE Resources CD
.
3.4
Quick Startup
Only a few steps are required to get the DEMO9S08QE8 up and running:
Step 1.
If you do not have CodeWarrior Development Studio version 6.0
installed on your computer, please install it using the
accompanying CD-ROM. Additional information regarding
CodeWarrior can be found at www.freescale.com.
Step 2.
Remove the DEMO9S08QE8 demonstration board from its anti-
static pouch. The green MC9S08QE8 daughter card should be
plugged into the header on the base board.
Step 3.
Connect the USB cable from your computer to the
DEMO9S08QE8 demonstration board. Depending on your
operating system, you may need to follow steps to install the USB
driver from the DEMOQE Resources CD-ROM. Once the USB
cable is connected properly the green USB LED on the
DEMO9S08QE8 should illuminate.
Step 4.
Turn on the DEMO9S08QE8 power switch (K6). The red Power
LED should illuminate.
Step 5.
Press the buttons labelled PTA2 and PTA3. When each button is
pressed a different tone will be emitted, and the light intensity of
the PTC0 LED will change. The LEDs labelled PTC1 and PTC2
(for PTA2) or PTC3 and PTC4 (for PTA3) should illuminate. In
addition, the light intensity of the LED labeled PTC1 should vary as
the potentiometer is rotated.
Step 6.
Optionally, you may run the DEMOQE Logic Analyzer Application
available in the DEMOQE toolkit on the CD. This PC-based
application graphs the IN0 and IN1 signals on the DEMOQE
board. If both J11 jumpers are installed, IN0 shows PTC0 and IN1
