Freescale Semiconductor MPC566EVB, User Manual

Page: 47 / 100

Chapter 2. Initialization and Setup 2-7
MPC566EVB Jumper and Switch Setup
Figure 2-3 on the next page shows the jumper locations for the board.
2-3 BDM being used runs at 2.6 volts.
BRK_EN *inserted SWITCH1 will act as a debounced Non-Maskable Interrupt
(ABORT)
removed SWITCH1 is for user use
B_RX *insterted CAN: see Section 1.4.2, “CAN PORTs and Options
removed CAN: see Section 1.4.2, “CAN PORTs and Options
C_TX inserted CAN: see Section 1.4.2, “CAN PORTs and Options
*removed CAN: see Section 1.4.2, “CAN PORTs and Options
C_RX inserted CAN: see Section 1.4.2, “CAN PORTs and Options
*removed CAN: see Section 1.4.2, “CAN PORTs and Options
100_IRQ *inserted Ties the interrupt line from the Ethernet chip to
the interrupt line of the processor
removed Disconnects the interrupt line from the ethernet chip to the
interrupt line of the processor
“ON” * insterted Allows the board to have power.
removed Power to the board should be controlled by an ignition switch
connected to the IGN input on the Power Clamp, TB1.
Table 2-2. Jumper Settings (Continued)
Jumper Setting Function
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..