X. CARE AND MAINTENANCE
42
WEEKLY CHECKS
Armrest adjustment knobs
Allow battery charger to go through a full recharge cycle. Wait until the green light
illuminates.
Clean paintwork with auto shampoo. DO NOT use harsh abrasives or power washer.
SIX MONTHS CHECKS
Tyre wear, replace as necessary.
All fasteners and fittings for sound function.
Battery connections.
Inspect all electrical plugs and sockets for damage, good contact and fit.
ANNUAL CHECKS
Front wheel bearings for wear.
Chassis for sound welds.
Rear drive wheel hub keys.
All wheel bolts.
Drive axle securing bolts.
Motor mounting bolts.
Magnetic motor brake disc and function.
Main wiring loom for damage.
All steering components.
Clean chassis and repaint any exposed parts.
Replace any damaged axle seals.
Cycle charge for full operation function.
Cycle test batteries for operating capacity.
Note: Annual inspection will include weekly, semi-annual and annual checks listed above.
LUBRICATION
Use a general purpose noncorrosive lubricating fluid (i.e. WD-40) on moving parts. All
wheel bearings are factory sealed and should not normally need lubricating. bearings should
be lubricated with a general purpose bearing grease. Your drive axle is factory filled with a
special lubricant and will not normally need replacing.
Note: Service interval recommendations are guidelines for proper care and maintenance
of your wheelchair. More frequent use of your wheelchair may require more frequent
adjustments to these suggested intervals listed above.
DO NOT mix other lubricants with this factory fitted drive axle lubricant.
Failure to observe this caution will invalidate your warranty.
Caution!
(Ask your authorized dealer for details.)
