7
MAINTENANCE
For optimal performance of the strength machine and to reduce the chances of injury to users, you must perform
preventive maintenance on a regular basis. Instruct all personnel to perform the procedures described in this
section. Personnel must also record and report any accident. To maintain the strength machine’s warranty, use
only FREEMOTION parts for repair or replacement. If there are any questions or concerns, see HOW TO CON-
TACT CUSTOMER CARE on the back cover of this manual.
DAILY MAINTENANCE
Upholstery and Frame—General Cleaning
1. Clean the strength machine using a soft cloth
dampened with a light solution of mild soap and
warm water. If necessary, use a soft bristle brush
with the cleaning solution.
2. Rinse the area thoroughly using a soft cloth damp-
ened with clean water and dry thoroughly.
Upholstery—Difficult Stains
1. Spray the stain with a non-abrasive household
cleaner such as FORMULA 409
®
cleaner, SIMPLE
GREEN
®
, or a similar product. Rub the stained
area gently and let the cleaning solution sit for a
few minutes.
2. Rinse the area thoroughly using a soft cloth damp-
ened with clean water and dry thoroughly.
3. Repeat these steps if necessary using a soft bristle
brush.
Optional Method for Difficult Stains
1. Rub the stained area gently using a soft cloth
dampened with rubbing alcohol.
2. Rinse the area thoroughly using a soft cloth damp-
ened with clean water and dry thoroughly.
CAUTION:
When using any cleaning product, try it
first in an unnoticeable place to ensure that there is no
damage to the material. Follow the directions and the
safety precautions of the manufacturer of each clean-
ing product used. FreeMotion Fitness and its vendors
cannot be held liable for damage or injuries resulting
from the use or misuse of cleaning products.
Important:
Do not use abrasive cleaners, which may
scratch the strength machine. Strong cleaners and
abrasives will damage decals; use caution around
decals. Do not use solvents such as lacquer thinner,
kerosene, gasoline, or similar liquids.
Towers and Frames
Wipe with a light solution of mild soap and warm
water. Rinse and dry thoroughly.
Stainless Steel Covers
Wipe with a light solution of mild soap and warm
water. Rinse and dry thoroughly. If desired, or to
remove corrosion, use a commercial stainless steel
polishing compound. Follow the directions and the
safety precautions of the manufacturer of the steel pol-
ishing compound.
Handles
Check all handle straps for wear. Visually check each
strap along the full length for signs of wear such as
cuts, tears, or nicks. Replace the strap immediately if
necessary. A “fuzz” will appear on straps over time and
is not a concern unless it appears to be worn through
strands of the weave.
Straps With Rings
If a ring is pulling through a strap or tearing away at
the edge of a strap, replace the strap immediately.
Check stitching points on straps for tears, worn spots,
or separation. Replace the strap if necessary.
Summary of Contents for Squat GZFM6010.4
Page 12: ...12 NOTES ...
