8
1. Place the Uprights (96) near the front of the
Base Frame (75) as shown.
Connect the 80" Wire Harness (46) in the Base
Frame (75) to the 55" Wire Harness (48) in the
right Upright (96).
See the inset drawing. The
connectors should slide easily and snap into
place.
If they do not, turn one connector and try
again.
IF THE CONNECTORS ARE NOT IN-
SERTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
96
75
48
46
1
46
48
2. Next, slide the Uprights (96) onto the Base
Frame (75), and align the holes in the Uprights
with the holes in the Base Frame.
Be careful
not to pinch the wires.
Tighten four 1/2" x 3 1/4" Bolts (1) with four 1/2"
Star Washers (7) and four 1/2" Jamnuts (5)
(only two of each are shown) into the Uprights
(96) and the Base Frame (75).
Start all four
Bolts before tightening any of them.
75
1
7
96
5
5
7
2
1
Summary of Contents for incline trainer i7.7
Page 2: ......
Page 43: ...41 NOTES ...
