9
5. Slide a Handrail Cover (76) onto the Left
Handrail (69).
See the inset drawing. Make
sure the curved side of the Handrail Cover is
facing the Upright (74).
Have a second person hold the Left Handrail
(69) near the Yoke (88). Locate the wire tie in-
side of the Yoke. Wrap the end of the wire tie
around the Left Pulse Wire (70).
Pull the other end of the wire tie until the Left
Pulse Wire (70) is extending from the hole in the
center of the Yoke (88). At the same time, insert
the Left Handrail (69) into the Yoke.
Make sure
not to pinch the Left Pulse Wire.
Then, slide
the bottom of the Left Handrail onto the bracket
on the Upright (74).
Attach the Left Handrail (69) to the Yoke (88)
with two 5/16" x 3/4" Bolts (6);
do not fully
tighten the Bolts yet.
Slide the Handrail Cover (76) up the Left Handrail
(69). Attach the Left Handrail to the Upright (74)
with two 1/4" x 1" Bolts (32) and two 1/4" Flat
Washers (25);
start both Bolts before tighten-
ing either of them.
Next, tighten the two 5/16" x
3/4" Bolts (6). Then, slide the Handrail Cover
down against the Upright.
Remove the wire tie from the Left Pulse Wire (70).
Repeat this step with the Right Handrail (75),
the other Handrail Cover (76), and the Right
Pulse Wire (71).
5
6
6
71
70
Wire
Tie
Wire
Tie
75
74
88
69
76
32
Bracket
76
32
Bracket
6. Slide the Accessory Tray (86) onto the Yoke
(88). Partially insert the two indicated tabs and
then partially insert the other tabs. Then, fully in-
sert all of the tabs.
Make sure not to break the
tabs.
Attach the Accessory Tray (86) to the Yoke (88)
with four #8 x 3/4" Screws (1).
Start all four
Screws before tightening any of them. Do
not overtighten the Screws.
6
86
Tabs
1
1
88
Hole
76
Curved Side
25
25
