10
6
7
6. Identify the Rear Shroud Base (3), which has a
hole in the center, and the Front Shroud Base
(4). Orient the Shroud Bases as shown.
Insert the end of the Cable (40) upward through
the Rear Shroud Base (3).
Attach the Shroud Bases (3, 4) to the Tower
Frame (1) with four M6 x 15mm Screws (35) and
four M6 Washers (34).
4
1
3
40
34
35
34
35
7. Pull the Drop-down Weight Knob (20) and slide
the Drop-down Weight (10) downward on the
Weight Guides (7).
Next, loosen the two M8 x 35mm Set Screws
(19) a few complete turns;
it is not necessary
to remove the Set Screws.
Look under the top of the Tower Frame (1) and
remove the two 25mm Snap Rings (39) from the
two Weight Guide Bushings (18).
Have a second person hold the Weight Guides
(7). Lift the Weight Guide Bushings (18) out of
the Tower Frame (1).
Then, tip the upper ends of the Weight Guides
(7) forward or backward, and slide the Drop-
down Weight (10) and the two Upper Weight
Bumpers (16) upward off the Weight Guides.
10
16
39
19
20
18
18
19
1
7
Summary of Contents for F820.0
Page 20: ...20 NOTES...