7. SYMPTOM: THE PEDALS SLIP OR GIVE ON THE
POWER STROKE OF EACH REVOLUTION
If the pedals slip on the power stroke, the drive belt
is slipping. You will need to adjust the tension of the
drive belt. Remove the nine 1/4" x 3/4" Button Head
Screws (59) from the Left Side Shield (6), and pivot
the Left Side Shield to the side.
Remove the Right Side Shield (7) in the same way.
22
Note: For clarity, the left pedal disk is not shown.
Rotate the pedal disk until the Drive Belt (15) is ac-
cessible.
Loosen the four 1/4" x 3/8" Cap Screws (49 [only one
is shown]). Tighten the Generator Tension Bolt (90)
1/4 turn until the Drive Belt (15) stops slipping.
Retighten the four 1/4" x 3/8" Cap Screws, and se-
cure the Left Side Shield with the nine 1/4" x 3/4"
Button Head Screws (59).
Secure the Right Side Shield (7) in the same way.
HOW TO REPLACE THE BATTERY PACK
If you are replacing the Battery Pack (95), see the
paragraph at the top of this page and pivot the left side
shield to the side.
Next, locate the Battery Pack (95). Disconnect the bat-
tery wire from the Lower Battery Wire (77). Cut the
wire ties and discard the Battery Pack according to
federal law.
Reverse this step to attach the new Battery Pack (95).
See the paragraph at the top of this page and reattach
the left side shield.
59
59
6
59
59
15
49
90
7
7
95
Wire Ties
Battery
Wire
77
Summary of Contents for Elliptical trainer
Page 2: ......
