12
12
12. Note: This step requires the parts that you
removed in step 9.
Pull the upper ends of the Weight Guides (34)
toward you. Tighten the two M16 Jam Nuts (76)
as far as possible onto the Weight Guides.
Next, slide the two M16 Split Washers (75), the
two Weight Guide Spacers (35), and the two
Plastic Washers (36) onto the Weight Guides
(34).
Make sure that the Weight Guide
Spacers are oriented as shown in the inset
drawing.
75
35
76
36
35
36
34
13. Note: This step requires the parts that you
removed in step 8.
Lift the Weight Guides (34) a few inches. Slide
the two Plastic Washers (36), the two Weight
Guide Spacers (35), and the two M16 Split
Washers (75) onto the Weight Guides.
Make
sure that the Weight Guide Spacers are
oriented as shown in the inset drawing. In
addition, make sure that the Weight Guide
Spacers are pressed into the indicated round
holes.
Then, tighten the two M16 Jam Nuts (76) onto
the Weight Guides (34).
13
75
35
76
36
35
36
Hole
34
35