37
68. Attach the Lower Shroud (33) to the Upper
Shroud (31) with two M6 x 16mm Screws
(88), four M6 Washers (92), and two M6
Locknuts (103).
See steps 66 and 67.
Tighten the ST4.2 x
16mm Screws (90) used in these steps.
68
69. Make sure that all parts are properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT beginning on page 38.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS starting on page 41 for proper cable routing. If there is any slack in the cables, you will
need to remove the slack by tightening the cables (see MAINTENANCE on page 43).
33
31
103
92
88
92
