out and lightly clamps the two mating parts together).
To prevent excessive tightening and damaging the fastener or parts, twist the driver from
the smaller diameter knurled section of the tool between your thumb and index finger for
small fasteners (under size M3) or with your thumb and two forefingers for larger fasteners
(size M3 and larger). {% endhint %}
{% hint style="danger" %} Before performing any part replacement, ensure that ATLA X has
been unplugged from any power source. Leaving ALTA X powered while performing any work
on it can result in a potentially dangerous situation. {% endhint %}
Replacing ActiveBlade Bumpers
1.
Push down on one side of the ActiveBlade assembly to open the gap and
provide better access. Pull the bumper out from that side.
2. Repeat this for the second bumper.
3.
To replace, insert the tail of the new bumper into the hole and pull into
place, until the shoulder is fully seated. A circular motion may help with
seating.
4.
To replace the second bumper, push down on the ActiveBlade assembly
and again pull the tail of the bumper to seat.
5.
Rock the the ActiveBlade assembly back and forth to make sure the
bumpers are aligned.
****
Replacing Propeller Sets
1.
First, remove the ActiveBlade bumpers as detailed in the previous
section.
2. Remove (2x) M5x30 bolts and (4x) M3x10 bolts and remove the top plate.
