Unfold
1.
Remove ALTA X from its box or travel case.
If you did not purchase the travel case with ALTA X; install the four
vibration isolation stand-offs to the four threaded holes on the
underside of ALTA X then mount the vibration isolator with (4x)
M4x14 Combo bolts.
Image not found or type unknown
2.
Use the built-in Toad in the Hole (TITH) on ALTA X’s vibration isolator to
mount ALTA X to your payload. If you are not using Skyview landing gear
your payload will act as ALTA X’s landing gear.
Make sure to latch the TITH once you feel the TITH fully seat; you will
hear a ‘click’ when seated.
3.
Fully unfold ALTA X’s booms; note that all of the booms are linked and will
open simultaneously.
4.
Secure the booms by latching both the red safety latches on ALTA X.
Always make sure both safety latches are fully latched before flying
ALTA X!
Batteries
1.
Adjust the battery tray to fit your preferred batteries by loosening and adjusting the
(8x) M3x6 SHCS fasteners securing the two movable tray components.
Ensure the fasteners are tightened after the trays have been adjusted.
