. . . . .
S E C U R I T Y Z O N E S A N D I N T E R F A C E S
Configuring Interface Modes
Version 3R2
Security Appliance User Guide
3-13
[NOTE]
To change the interface mode from NAT Mode to Route Mode,
use the
set interface (interface name) route.
E X A M P L E : C O N F I G U R E R O U T E M O D E
Configure route mode on the eth0 and eth1 interfaces of the appliance
displayed in
Figure 3-8
:
set interface eth0 route
set interface eth1 route
save
G U I E X A M P L E : C O N F I G U R I N G R O U T E M O D E
1
Network > Interface > Edit (for eth0)
2
Enter the following, then click
Apply
:
Interface Mode: Route
3
Network > Interface > Edit (for eth1)
4
Enter the following, then click
Apply
:
Interface Mode: Route
Figure 3-8: Route Mode
All traffic from eth0 to eth1 and from eth1 to eth0 maintains their
original source IP addresses.
VIEWING INTERFACE INFORMATION
Use the
get interface
command to display interface information. The
following information appears for each physical and logical interface:
•
Name
—The name assigned to the interface.
