4
|
P a g e
Rev 11.2016
Cleaning and Maintenance
1.
Clean the bathtub with ordinary liquid detergent and a soft cloth. Don’t sterilize the
bathtub with cleaning products containing acetone or ammonia. Do not disinfect
using agents with formic acid or formaldehyde.
2.
If scratched treat the surface with an acrylic rubbing polish.
3.
Wipe off the dirt and stains on surface with toothpaste and a soft cloth.
4.
Grind the light scratches or stains with 2000# sand paper, and then polish with
polishing wax.
5.
If water is hard, it is suggested to clean the massage the device twice a year according
to this following method:
a.
Feed 40
°
C warm water into the bathtub until it reaches the lowest water level.
b.
Mix 2g of liquid detergent for every liter of water, pour in and start the water
force massage device and allow it to run for about 5 minutes.
c.
Stop the water pump and drain out the water.
d.
Fill the bathtub again with cold water and start the massage jets for about for
3 more minutes.
e.
Stop the water pump, drain out the water, and clean the bathtub.
