3
|
P a g e
Rev 11.2016
Operation of Bathtub
1.
Check the power supply and GFCI protection. Insert the plug into an interior power
supply socket or hardwire to a junction box.
2.
Turn on the cold and hot water shut eff valves, and then turn on the handle of the
cold and hot water faucet to mix the water to a desirable temperature.
3.
Operation of the faucets: an on/off valve has been set for the shower and whirlpool
bath. Turn diverter to switch between water faucet and sprayer functions.
4.
Whirlpool bath massage: Turn valve on. Turn off the water when it reaches the water
level. Water pump valve controls the whirlpool massage pump and jets.
1.
Drain water for about 10 minutes after installation to clear drain lines and test for
water leaks.
2.
After using, shut off water and power supply.
Troubleshooting
Trouble
Reason
Solution
No Power Supply
1.
Power plug is not
connected to the socket
2.
Circuit breaker is not on
1.
Tightly connect the plug with the
socket.
2.
Find and remove short circuit,
reconnect the protection switch.
Water pipe leaks
1.
Poor seal ring
2.
Poor joint connection
3.
Water pipe is broken
1.
Replace
2.
Connect it again
3.
Replace
Tub light doesn’t work
1.
Bulb is damaged
2.
Wires are cut off
1.
Replace (remove the nut and
install a new bulb, then tighten it)
2.
Connect the wire
