7
Obtain an IP Address Automatically
Computers commonly use this setting to obtain an IP
address automatically.
1. If
Obtain an IP address automatically
is
selected, it may be best to click the
Alternate
Configuration
tab.
2. Select
User Configured
.
3. Enter an IP address. For simplicity, make the last
segment of the IP one number different than the IP
address of the console.
Upon initial setup
ONLY
,
the numbers used in the figure may be used to
configure the TCP / IP settings of your PC.
After
initial startup the programmed parameters should
be verified through the touchscreen
4. Leave all other information blank and click
OK
.
5. Close the Local Area network for changes to take
place.
Note:
The consoles default IP address is
192.168.168.168. If the PC is normally configured
to acquire an IP address automatically,
Alternate
Configuration
may be used, as mentioned above, to
allow a connection to be enabled without the necessity
of reconfiguring the computer each time it will be used
to connect to this console.
Use the Following IP Address
1. If
Use the following IP address
is selected and
the entry boxes contain any information, record this
information for use when console programming is
complete.
2. Enter an IP address. For simplicity, make the last
segment of the IP one number different than the IP
address of the console.
Upon initial setup
ONLY
,
the numbers used in the figure may be used to
configure the TCP / IP settings of your PC.
3. Leave the DNS information blank.
Note:
The consoles default IP address is
192.168.168.168. If the PC is normally configured
to
Use the following IP address
, make sure that
all displayed information is recorded and kept prior
to making any changes. It may be necessary to use
this information to re-configure the console once
programming is complete.
Check Status of Connection
1. Check the status of your connection by going to
the
Network Connections
window.
2. If the connection status is disabled, enable it by
right-clicking on the
Local Area Connection
and
selecting
Enable
.
3. Verify link light is lit under Ethernet on Controller
module is lit and RX light is flashing.
If technical
difficulties arise, please contact Franklin Fueling
Systems Technical Support before proceeding.
Summary of Contents for INCON TS-550evo
Page 22: ... 2013 FFS 000 0536 Rev A ...
