SAFETY INSTRUCTIONS
Product Specific Precautions
6
Product Specific Precautions
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
•
Do not remove drive cover for wiring or periodic inspec
-
tions while power is applied, or the unit is in operation.
•
Capacitors inside the drive can still hold lethal voltage
even after power has been disconnected—ALLOW 5 MIN
-
UTES FOR DANGEROUS INTERNAL VOLTAGE TO DIS
-
CHARGE BEFORE REMOVING COVER OR WORKING WITH
INTERNAL COMPONENTS.
•
Perform wiring after drive has been mounted. Otherwise,
electric shock or bodily injury can occur.
•
Operate drive and control devices with dry hands.
•
Do not use drive if power or motor cable is damaged.
•
Do not apply power to a damaged drive or to drive with
missing parts.
•
Do not use motor in swimming areas.
Risk of damage to drive or other equipment.
•
Install and wire drive according to the instructions in this
manual.
•
Take protective measures against ESD (Electrostatic Dis
-
charge) before touching control boards during inspection,
installation or repair.
•
This product is recommended for use with Franklin Electric
4-inch submersible motors as specified in this manual.
Refer to
“Common Specifications” on page 37
. Use of this
unit with any other Franklin Electric motor or with motors
from other manufacturers may result in damage to both
motor and electronics.
•
In applications where water delivery is critical, a replace
-
ment pressure sensor and/or back-up system should be
readily available if the drive fails to operate as intended.
