Franke Frames CM FS 45 BK, Installation And User Manual

Page: 21 / 134

– 19 –
CM FS 45 BK
EN
Cleaning the pre-ground coffee funnel
X X
Check regularly (about once
a month) that the pre-ground
coffee funnel is not blocked.
Cleaning the inside of the coffee maker
X X
Check regularly (about once
a week) that the inside of
the appliance is not dirty. If
necessary, remove coffee
deposits with a sponge.
X X
Remove the residues with
a vacuum cleaner.
Cleaning the brewing unit
The brewing unit must be cleaned regularly to avoid
the build-up of coffee encrustations which could
cause malfunction.
Note: The brewing unit can only be taken out when
the appliance is switched off by pressing the on/
Stand by button (Aa). Otherwise, the coffee machine
may be seriously damaged.
Proceed as follows:
X X
Turn the appliance off by pressing the on/stand by
button (Aa)
(do not switch off the main switch or
unplug)
and wait for the display to go off.
X X
Open the service door.
X X
Remove the drip tray and the waste coffee
container.
X X
Press the two colored release
buttons inwards and at the
same time pull the brewing unit
outwards.
X Z
Clean the brewing unit under
running tap water without using
detergent. Never clean the
brewing unit in the dishwasher.
X Z
Do not use washing up liquid to clean the brewing
unit. It would remove the lubricant applied to the
inside of the piston.
X X
Soak the brewing unit in water for about 5 minutes,
then rinse.
X X
After cleaning, replace the
brewing unit (L) by sliding it
onto the internal support (S)
and pin (P) at the bottom,
then push the PUSH symbol
fully in until it clicks into
place.
Note: If the brewing unit is
difficult to insert, you must first
adapt it to the right dimensions
by pressing it forcefully from
the bottom and top.
X X
Once inserted, make sure the two colored buttons
have snapped back out, otherwise the service
door cannot be closed.
– The two colored buttons are correctly snapped
out (A).
– The two colored buttons are not snapped out (B).
X X
Replace the drip tray and waste coffee container.
X X
Close the service door.
Note:
– If the brewing unit is not put in place correctly,
the service door cannot be closed.
– If it is difficult to insert the brewing unit, it must
be made into the right height (before inserting) by
pressing the brewing unit firmly together from top
and bottom.
– If it is still difficult to insert the brewing unit:
X X
Leave it out of the appliance, place the drip tray,
close the service door, switch the main switch on
the back of the appliance to ‘off’ and then to ‘on’
again.
X X
Wait for all the lights to go off, then open the door,
remove the drip tray and replace the brewing unit.
X X
Replace the drip tray, together with the grounds
container.
X X
Close the service door.