Franke Frames CM FS 45 BK, Installation And User Manual

Page: 13 / 134

– 11 –
CM FS 45 BK
EN
9
Empty the container used to collect the water used for rinsing.
9
Take out the water tank, empty the watertank and fill it with clean water.
9
Put the water tank back in place and put the container back under the coffe
spouts and the hot water spout. The display shows: RINSING PRESS OK.
X X
Press the touch key (
5
).
„ „
Hot water flows out of the hot water spout.
„ „
Once the rinsing is finished, the display shows RINSING COMPLETE PRESS OK.
X X
Press the touch key ( 5 ).
„ „
The appliance goes off automatically.
Note: If the descaling cycle is interrupted before completion, the appliance
continues to display the descale message and the program must be
started again from the beginning.
Failure to descale the appliance invalidates the guarantee.
INSTALLATION
IMPORTANT
X Z
After removing the packaging, make sure the
product is complete and undamaged. If in doubt,
do not use the appliance and contact a qualified
professional.
X Z
Installation must be carried out by a qualified
techncian and in compliance with current
regulations.
X Z
Packing elements (plastic bags, polystyrene etc.)
must not be left within reach of children as they
may represent a hazard.
X Z
Never install the appliance in environments where
the temperature may reach 0 °C or lower (the
appliance may be damaged if the water freezes).
X Z
Make sure the mains voltage corresponds to the
voltage indicated on the appliance rating plate.
Connect the appliance to an efficiently earthed
socket with a minimum current rating of 10A only.
The manufacturer may not be considered liable
for possible incidents caused by the failure to
adequately earth the mains.
X Z
Make sure the socket used is freely accessible at
all times, enabling the appliance to be unplugged
when necessary.
X Z
Never touch the plug with damp hands.
X Z
Never pull the power cable as you could damage it.
X Z
This appliance can be installed over a built-in oven
it he latter is fitted with a cooling fan at the rear
(maximum power: 3KW).
X Z
Do not use multiple plug adapters or extension
leads.
X Z
The power cable on this appliance must not be
replaced by the user as this operation requires
the use of special tools. If the cable is damaged or
requires replacing, contact an authorised service
centre only to avoid all risks.
X Z
You should personalise water hardness as soon as
possible following the instructions.
Building in
X X
Please check the minimum measures necessary
to the proper installation of the appliance. The
coffee maker must be installed in a column unit,
which must in turn be fixed to the wall (Fig. 1,
page 25).
X X
Position the appliance on the rail, making sure the
pins are correctly inserted in the housing, then fix
it with the screws supplied (Figure 4).
X X
If the height of the appliance requires adjusting,
use the spacer disks provided.