10
GENERAL ASSEMBLY PROCEDURE FOR INSTALLATION
PLEASE KEEP AND READ FOR FUTURE REFERENCE
GAS CONTROLS - LIGHTING PROCEDURE
_______________________________________________________________________________________________________________________
NOTE: ALWAYS ENSURE ALL PARTS ARE CLEAN AND DRY PRIOR TO OPERATING ANY BURNER.
It is important that the burner assembly sequence on the previous page is performed prior to initial operation of the cook top or light
back may occur which could affect the burner.
WHEN INSTALLED IN A CARAVAN OR MARINE CRAFT DO NOT USE THIS APPLIANCE AS A SPACE HEATER. DO NOT
PLACE COMBUSTIBLE MATERIAL OR PRODUCTS ON THIS APPLIANCE AT ANY TIME. DO NOT USE AEROSOLS NEAR THIS
APPLIANCE WHILST IT IS IN OPERATION.
1.
Select the control knob corresponding to the burner you wish to use, press down and turn the knob to the position shown below.
NOTE: BURNERS WILL IMMEDIATELY BEGIN SPARKING VIA THE ELECTRONIC IGNITION SYSTEM WHEN ANY OF THE
GAS CONTROLS ARE DEPRESSED. IF THERE IS NO IGNITION SPARK THEN THE APPLIANCE MAY NOT HAVE THE POWER
TURNED ON. CHECK THE POWER POINT AND CONFIRM THE UNIT HAS POWER.
2.
Press and hold the control knob down firmly for a full 5 seconds to ensure the flame failure device engages. If the flame goes
out after you release the knob then the flame failure device did not engage – simply press down the knob firmly again turn to max
position and keep pressing for a full 5 seconds.
MAINTENANCE SCHEDULE
_______________________________________________________________________________________________________________________
The appliance should be kept in a clean condition and you should ensure that removable parts are correctly reassembled. If the
appliance has not been used for a long period of time check the appearance and the general performance of the burners. If the
supply cord is damaged, it must be replaced by the manufacturer, its service agent or authorized person in order to avoid a hazard.
In any event the appliance should be checked by a qualified person every five years and / or you should contact your dealer for any
recommended maintenance.
MAXIMUM POSITION- FULLSPECTRUM
BURNER CONTROLS
MAXIMUM POSITION-
A, B AND C BURNER
CONTROLS
ADJUSTMENT RANGE FOR
OUTER BURNER OPERATION-
FULLSPECTRUM BURNER
ADJUSTMENT RANGE FOR
INNER BURNER OPERATION-
FULLSPECTRUM BURNER
ADJUSTMENT RANGE FOR
BURNER OPERATION- A, B
AND C BURNERS