29
Switching the alarm off
When the preset time expires a beep is heard which you can either turn off by
touching any sensor or leave it to turn off automatically after 2 minutes.
If you want to switch the timer off prior expiry of preset time:
With the hob off:
• Touch the hob ON/OFF sensor (C) to activate the cooking hob.
• Touch the timer ON/OFF sensor (E+D).
• By touching the sensor »-« (D) set cooking time to »00«. Alarm function is
off.
Simultaneously touch both »+« and »-« (E+D) sensors and switch the timer
off.
• During the time the alarm is activated, timer can be preset for any hotplate.
Service menu/
Manual configuration
Prerequisites for configuration/deleting (configuration)
All pans must be removed from cooking zones and one suitable for induction
must be available. The size of this pan should be at least 80% of the largest
inductor diameter to be configurated (e.g. inductor Ø200mm
→
pot size>
Ø160mm)
It’s possible starting configuration/deleting within 2 minutes after connection
to power mains. Touch control and all displays must be turned off.
Getting in configuration/deleting menu’
Hold the minus key (6) pressed.
Press all keys of cooking zones’ selection anticlockwise, starting off with the
first right one (5-4-3-2).
For 4 zones version the sequence is: (5-4-3-2)
For 3 zonesversion the sequence is: (4-4-3-2)
For 2 zones version the sequence is: (4-4-3-3)
Every action is acknowledged by a signal tone:
#
Only one “beep”
→
correct selection
#
Double “beep”
→
wrong selection
After the last action all induction displays turn on, where it’s displayed:
#
“-”
→
it means configured zone
#
“C”
→
it means NOT configured zone
Procedure of deleting configuration
After getting in configuration/deleting menù:
Hold the minus key (6) pressed: “E” is displayed on the displays of all
cooking zones. “E” keeps flashing until all cooking zones will be not
configured.
“C” will be displayed on all displays.
Procedure of configuration
After getting in configuration/deleting menu and completing deleting
configuration:
(During configuration phase all displays of cooking zones display “C”)
Cooking zone to be configured can be selected by cooking zone’s selection
key.
“C” will start flashing on the corresponding display.
Within 20 seconds a pan must be placed on the corresponding zone in the
way that the cooking zone can detect the correct position.
#
If within 20 seconds cooking zone detects a pan the simbol “-” will appear
(cooking zone is correctly configurated);
#
If after 20 seconds cooking zone doesn’t detect a pan the letter “C” will
appear; try again configuration procedure from the first point.
This procedure must be applied to every cooking zone.
Configuration menù stops:
Automatically after the configuration of all cooking zones.
Manually by pressing the key ON/OFF (1), if you want to configure only
certain cooking zones.