EN
8
8
T2
T1
L
T3
USE - MAINTENANCE
USE
Control panel
BUTTON LED
FUNCTIONS
T1 Speed
On
Turns the Motor on at Speed one.
Turns the Motor off.
T2 Speed
On
Turns the Motor on at Speed two.
T3 Speed
Fixed
When pressed briefly, turns the Motor on at Speed three.
Flashing
Pressed for 2 Seconds.
Activates Speed four with a timer set to 10 minutes, after which it
returns to the speed that was set previously. Suitable to deal with
maximum levels of cooking fumes.
L
Light
Turns the Lighting System on and off.
Warning: Button T1 turns the motor off, after first passing to speed one.
MAINTENANCE
N.B. Before any maintenance, repairs or when changing the lights, always disconnect the appliance from the
power supply.
1. Lighting
This is provided by two 40 W lamps. To change these, proceed as follows (fig. 10):
Remove one of the pins at the sides of the light fixture. Slide the glass towards the side without the pin, until
the opposite side is freed, then pull gently downwards. Change the lamps and reassemble the glass by pro-
ceeding in reverse order.
2. Filters
At more or less frequent intervals, according to how much the hood is used, and in any case at least once
every 2 months, the metal filters should be dismantled and washed in hot, soapy water, or directly in the
dishwasher, then dried and replaced (the activated charcoal filters must never be washed, and must be re-
placed every 2 months).
3. Cleaning
To clean the exterior of the hood use a cloth damped with alcohol or other suitable commercially available
products. Do not use abrasive substances.
IMPORTANT: Use of an open flame may damage the filters, so it is not recommended that the gas burners
be left turned on without a pan over them. The hood and filters must be cleaned and replaced according to
the instructions provided in order to avoid the risk of fire.
WARNING: The manufacturer will not be considered liable for any damage caused by failure to carry out
maintenance on the metal grease filter (washing every two months), replacement of the activated charcoal fil-
ter and failure to comply with the instructions for fitting and electrical connection provided above
.
