9
Reserved to qualified operators
Connect the machine to a mains electrical network protected by a circuit breaker with a sensitivity equal to or less than 30 mA.
Warning!
If the power cable is damaged, it must be replaced by the manufacturer, by an authorized technical assistance provider or else by an
individual with similar qualifications, in order to prevent any risks.
5 INSTALLATION
• This water dispenser can be equipped with a WATER BLOCK anti-
flooding device (optional) to prevent any accidental water leaks (Fig. 13).
Once the WATER BLOCK device has intervened, fitting
K
should be dis-
assembled and button
P
pressed to reset the device.
• If instead of being connected directly to the aqueduct the machine is con-
nected to an autoclave pump, then it is necessary to install above the wa-
ter supply an ANTISHOCK device to prevent “water hammers” (Fig. 14).
5.4 DRAIN CONNECTION
The drain water is clean and it comes from the tray that collects any dripping
during dispensing.
Connect the drain pipe ( ext. ø24mm) to a drain with a drain-trap.
If necessary, cut the pipe so as to avoid constrictions or backflow problems.
EN
5.5 HYGIENIC CLEANING
• Once you have checked that the appliance operates correctly, proceed
with the “internal cleaning and hygienic cleaning” phase as described in
chap. 6.
5.6 ELECTRICITY CONNECTION
Connection to the mains electricity supply is carried out by connecting the
plug to a mains socket.
The supply socket must be equipped with an efficient earth plate and it must
be sized for the load of the appliance (see technical characteristics).
Make sure that the mains voltage corresponds with what is specified on the
data plate.
Make sure that there is an omnipolar switch above the socket with a minimum
contact break of 3 mm protected by fuses of suitable amperage for the ab-
sorption of the appliance itself (see technical characteristics and data plate).
• Turn the cold water regulator screw
F
(Fig. 15) (4 to 7 positions are ad-
vised).
12
13
14
15
P
K
F
