Franke 7612982239618, Operating Instructions Manual

Page: 7 / 20

- 7 -
ZMI
_001_
2030
0366
21-E
X
OS
0027
_#SE
N
_#AQ
U
_#V2
.f
m
10. Installing the electrical T-distributor
☞
Important!
The components of the electrical T-distributor may only be installed after the power
has been switched off.
☞
Recommended system cable see Chapter 17. , accessories.
When using cables other than the system cable, pay attention to the different colour
code. The outer diameter must not exceed 7.5 mm.
10.1 Remove the sheathing (a) of the system cable (approx. 40 mm).
10.2 Push the cap nut (c) onto the system cable (b) up to the stop.
☞
The various wire guides are marked with numbers 1 to 4.
A: Union nut
B: FAR-Best.-Nr. 2000104272
FAR-Best.-Nr. 2000104274
FAR-Best.-Nr. 2000100801
FAR-Best.-Nr. 2000100852
10.3 Push the wires (d) into the wire guides (e) in accordance with their colours.
10.4 Cut off the projecting wire ends flush, i.e. without protrusions.
10.5 Push the cap nut (c) onto the electrical T-distributor (f) and tighten with the required
torque (1.2 Nm).
Caution!
Note the polarity.
The same wire colour must be in the same wire guide for both union nuts.
☞
When tightening the union nut, the electrical contact and tension relief are created
automatically.
Special seals act as protection from dust and water.
A B
1 brown red
2 white white
3 blue blue
4 black black