ZMI
_001_
2030
0366
21-E
X
OS
0027
_#SE
N
_#AQ
U
_#V2
.f
m
- 8 -
11. Assembly
Preparing the electrical connection
☞
The power supply should be installed in a separate room outside the wet area and
secured with a residual current device (RCD).
11.1
Install the cistern (a).
11.2
Install the electrical T-distributors (b, c) (see
11.3
Attach the motor (d) inside the cistern (see motor instructions).
11.4
Connect the motor (d) to the first electrical T-distributor (b).
11.5
Engage the pressure coil of the cistern (a) on the motor (d).
A: Cable motor (actuator 1)
B: Actuator 2 (optional)
C: Not used
D: Not used
E: Not used
F: Connection for the sensor to be provided by the customer (e.g. door contact)
G: Optical sensor
H: Electrical T-distributor system cable (power)
K: Electronic module
11.6
Connect the cable of the motor (d) to the cable (A) of the electronic module (K).
11.7
Connect the optical sensor via the adapter cable to the electronic module.
Optional
11.8
Connect the sensor to be provided by the customer (e.g. door contact).
11.9
Optional: Connect the second sensor.
e … adapter cable for sensors
f … door contact
g ... yellow
h … brown
11.10
Optional: Connect the third sensor.
e … adapter cable for sensors
k … flush trigger for disabled persons
l … white
m … green (use in combination with Y-sensor distributor 2/3 wire colour "yellow")
11.11
Connect the electronic module (K) to the second electrical T-distributor (c).
11.12
Place the electrical T-distributor (b) into the cistern.
