- 9 -
ZMI
_001_
2030
0366
21-E
X
OS
0027
_#SE
N
_#AQ
U
_#V2
.f
m
Installing the cover plate
11.13
Insert the screws (o) into the tabs (n).
11.14
Turn the screws by 90°.
11.15
Install the frame (p).
11.16
Connect the optical sensor to the electronic module.
11.17
Fit the cover plate (q) and screw it down.
12. Function
12.1
Leave the sensor area.
• The flush system will be activated.
• Flushing will stop automatically.
☞
An automatic hygiene flushing function after 24 hours of non-use has been
factory-set.
Function with door contact (optional):
Pre-flushing takes place once when the door is closed.
There is a minimum time interval of 5 minutes between two pre-flushes.
If the door remains locked for more than one minute and the sensor or trigger for the
disabled is not activated during this time, the flush will be automatically activated
when the door is unlocked.
13. Setting the range
The range can be adjusted using an ECC2 function controller via the web
application.
14. Setting the hygiene flush
The hygiene flush can be adjusted with an ECC2 function controller via the web
application.
15. Maintenance and care
The tap must be checked and maintained at regular intervals, depending on the
water quality and in accordance with the local conditions and rules and regulations
applicable at the site.
Use suitable cleaning agents which do not attack the tap in a proper manner and
rinse with water after use. High-pressure cleaners must not be used for cleaning.
