5
EN
Manufacturer
data:
Contact details:
European standard
FRAM GmbH
FRAM GmbH
ndustriestrasse 12/22
49324 Melle
www.fram-gmbh.de
EN 14543 + A1
INSTALLATION
WE RECOMMEND THE OUTDOORFIRE GAS OUTDOOR HEATER TO BE INSTALLED AND / OR SE-
RVICED BY A QUALIFIED SPECIALIST.
DO NOT ATTEMPT TO MODIFY THE CONSTRUCTION OF THE DEVICE OR ITS COMPONENTS.
ANY MODIFICATION WILL CAUSE IMMEDIATE LOSS OF WARRANTIES AND CERTIFICATES.
PLEASE NOTE: AVOID THE RECOMMENDATIONS OF THESE INSTRUCTIONS WITH REGARD TO
INSTALLATION, OPERATION OR AVOIDING THE RECOMMENDATIONS CONCERNING AUTHO-
RIZED PARTS AND ACCESSORIES FOR THIS APPLIANCE MAY RESULT IN SERIOUS INJURIES OR
DAMAGE TO PROPERTY.
THIS APPLIANCE HAS BEEN DESIGNED IN ACCORDANCE WITH RESTRICTED SAFETY STANDARDS
AND RECOMMENDED. IT WAS TESTED AND CERTIFIED BY A NOTIFIED BODY ACCORDING TO EN
14543.
It is important to periodically check the proper functioning and integrity of individual components
of the gas control system, as well as structural elements for any damage. It is very important that the
gas control system remains intact and free from any damage. The device can be serviced only by a
qualified technician with appropriate qualifications. Failure to comply with these rules may result in
serious health damage and even death and property damage.
Installation and use must be carried out in accordance with national building regulations. Your au-
thorized dealer can help you determine what safety precautions should be taken when installing
or using the device. In some cases, you may need to obtain permission to install or operate such a
device. Always consult an authorized dealer or building inspector to determine which regulations
apply to the use and / or installation of the device in your area. In the absence of provisions gover-
ning installation and use, it is essential to comply with the instructions in the manual and the fire
safety code.
Do not switch on the device if any of its components has been previously dismantled, damaged
or destroyed. Before reuse, the missing or damaged part must be replaced by the original replace-
ment provided by the manufacturer.
GENERAL INFORMATION
IMPORTANT: KEEP THESE INSTRUCTIONS!