20
EN
Fig. 11. Anti-tilt valve, installed on the regulator in the device.
ATTENTION!
Gas garden fireplaces are designed to work with a propane and propane-butane cylinder in size of 5
and 11 kgs (the sizes may vary depending to the country you are buying them in).
The device is sold with complete automation, tilting valve, reducer and connecting hose. Do not use a
hose other than recommended by the manufacturer, or any other system components.
You can buy GOK hose from FRAM GmbH or ask your serviceman or salesman to provide information
on the hose type that can replace the original one.
ATTENTION!!!
The appliance should be connected to the gas source only when the heater is turned off and the
cylinder valve is turned off.
Never connect the gas cylinder directly to the appliance without the regulator!
Before replacing the cylinder, make sure that the device is not near to any sources of fire or
other sources that could ignite.
It is essential to close the gas supply valve on the cylinder or regulator after each use.
f you feel any gas leakage, you must absolutely stop using the device, if it is running turn it off
or if it is turned off, do not start it. Then switch off the valve on the gas cylinder and contact
the service center.
ATTENTION!!!
It is forbidden to use open fire during the installation process or connecting the cylinder. Failure to
comply with this prohibition may result in fire, explosion, property damage, personal injury, and
even loss of life.