FRAM FMG-MDT2500X, Manual, Page: 16 / 40

15
ASSEMBLING
•
Press the fasten button, hold the
head and insert it into the inlet(when
inserting please pay attention the
head must be adjust the appropriate
direction until close to and inlet, see
fig.1). Then push the locking handle
until the vertical position and tube
(fig.2).
•
Place the snake into the head, long
end first, and turn to feed the screw
slightly until it is set into the motor
housing (fig.3).
•
Place the cutting blade onto the
snake shaft with the blade facing the
front as illustrated (fig.4). If it is not
fitted properly, meat will not be
grinded.
•
Place the desired cutting plate next
to the cutting blade, fitting
protrusions in the slot (fig.5).
•
Support or press the center of the
cutting plate with one finger then
screw the fixing ring tight with another hand (fig.6). Do not over tighten.
•
Place the hopper plate on the head and fix it into position.
•
Locate the unit on a firm place. The bottom and surrounding air vents should be properly reserved and
not completely blocked.
•
The air passage at the bottom and the side of the motor housing should be kept free and not blocked
(fig.7).
MINCER
•
Insert the worm shaft into the cutter housing, the plastic end first.
•
Place the cutter unit onto the worm shaft (the cutting edges should be at the front). Place the medium
grinding disc or coarse grinding disc (depending on the consistency you prefer) onto the worm shaft.
(Make sure the notch of the grinding disc fit onto the projections of the mincer head.) Turn the screw
ring in the direction of the arrow on the cutter housing until it is properly fastened.
•
Attach the cutter housing to the motor unit.
•
Place the tray on the upright part of the cutter housing.
•
Now the appliance is ready for mincing.
5. USING THE APPLIANCE