27
1.
Setting conditions of this appliance is indicated in tag or data plate.
2.
Your appliance should be plugged in a fuse appropriate for electric power. If necessary, it is
recommended that installation is done by authorized service.
3.
Your appliance is configured in accordance with electrical supply of 220-240V 50/60Hz.
4.
If main electrical network is different from these values, contact with your authorized service.
5.
Electrical connections of your appliance should only be made to the fuses having suitably wired
grounding (grounded) system. If no convenient fuse is available in the place where your appliance is to be
installed, contact with authorized service immediately. Manufacturing firm is not responsible definitely for
the damages that fuses whose grounding is not made and connected to the appliance can cause.
6.
Plug of the appliance should be close to be accessed easily to the fuse whose grounding is made
without use of extension cord.
7.
Do not allow contacting the power cable of your appliance with hot regions. Similarly, keep away it
from sharp edges and corners.
8.
If feeder cord is damaged, this cord should be replaced either by manufacturer or its service agency
or same degree qualified personnel in order to hinder a dangerous situation.
9.
Wrong electrical connection may give damage to the appliance.In this case, your appliance will
remain out of guarantee scope. Electrical connection of your appliance should be done by authorized service.
WARNING:
Before starting any work related with gas installation, turn off gas supply. Risk of explosion.
1.
Connect your appliance to gas cock from the shortest way and in a manner to prevent any leakage.
For safety, the hose used should be maximum 125 cm and minimum 40 cm.
2.
While making gas leakage control; never use lighter, match, glowing cigarette or similar inflammable
matter.
3.
Apply soap bubble on connection point. If any leak/leakage exists, foaming will occur on soaped
region.
4.
If the built-in hob is to be mounted on a cabinet or openable drawer, a heat protection panel having
15 mm minimum opening should be mounted under the built-in hob.
For LPG connection.
For LPG (cylinder) connection, affix metal clamp on the hose coming
from LPG cylinder. Affix an edge of the hose on hose inlet connector
behind the appliance by pushing to end through heating the hose in
boiled water. Afterward, bring the clamp towards end section of the
hose and tighten it with screwdriver. The gasket and hose inlet
connector required for connection is as the picture shown below
NOTE
: The regulator to be affixed on LPG cylinder should have 300
mmSS feature.
7.
ELECTRICAL CONNECTION AND SAFETY
8.
GAS CONNECTION AND SAFETY
