Fragram MCOM1256 Manual Download Page 8

 

 

 

WARNING:

 

Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient 

to inflict serious injury. 

WARNING: 

Always wear safety goggles or safety glasses with side shields when operating tools.    Failure to do so could result 

in objects being thrown into your eyes, resulting in possible serious injury. 

WARNING: 

Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of 

attachments or accessories not recommended can result in serious personal injury. 

 

OPERATION 

 

Operating the Trimmer 

 

WARNING: 

Always position the unit on the operator’s right side. The use of the unit on the operator’s left side will expose the 

user to hot surfaces and can result in possible burn injury. 

WARNING: 

To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level. 

 

Hold the trimmer with your right hand on the rear handle and your left hand on the front handle. Keep a firm grip 

with both hands while in operation. Trimmer should be held at a comfortable position with the rear handle about hip 

height. 

Always operate trimmer at full throttle. Cut tall grass from the top down. This will prevent grass from wrapping 

around the shaft housing and string head which could cause damage from overheating.   

If grasses become wrapped around the string head, STOP THE MOTOR, Pull out the plug from the extension 

socket and remove grass from the trimmer. Prolonged cutting at partial throttle could result in grass fires. 

WARNING: 

Always hold the string trimmer away from the body keeping clearance between the body and the product. Any 

contact with the housing or string trimmer cutting head can result in burns and/or other serious personal injury. 

TO ADVANCE THE CUTTING LINE 

String advance is controlled by tapping the string head on grass while running engine at full throttle. 

1. 

Run engine at full throttle. 

2. 

Tap the spool retainer on ground to advance string. The string advances each time the spool retainer is tapped. 

Do not hold the spool retainer on the ground. 

NOTE:

 The line trimming cut-off blade on the grass deflector will cut the line to the correct length. 

NOTE:

 If the string is worn too short you may not be able to advance the string by tapping it on the ground. If so, 

stop the engine, and manually advance the string. 

 

Summary of Contents for MCOM1256













Reviews: