INSTALLING THE POWER HEAD TO THE ATTACHMENT
See Figure 2.
WARNING:
Never install, remove, or adjust any attachment while power head is running. Failure to stop the engine can cause
serious personal injury.
The attachment connects to the power head by means of a coupler device.
1.
Loosen the knob on the coupler of the power head shaft and remove the end cap from the attachment.
2.
Push in the button located on the attachment shaft. Align the button with the guide recess on the power head
coupler and slide the two shafts together. Rotate the attachment shaft until the button locks into the positioning
hole.
NOTE:
If the button does not release completely in the positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked into place.
3.
Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to
avoid serious personal injury.
REMOVING THE ATTACHMENT FROM THE POWER HEAD
For removing or changing the attachment:
4.
Loosen the knob.
5.
ATTACHING THE STORAGE HANGER
See Figure 2 and 3.
There are two ways to hang your attachment for storage.
1.
er end of the attachment
shaft. Slightly rotate the cap from side to side until the button locks into place.
2.
