The Effects
50
TEMPO L/R -
Locks the delay time to the global tempo. For example, if the global tempo is 120
bpm and the tempo is set to a quarter note (1/4) then the time will be 500 ms (one echo per beat).
To ignore the global tempo set the tempo control to
NONE
.
FEEDBK L->L/R-.R -
Sets the amount of delay feedback for the delay line. This controls how many
repeats are heard.
FEEDBK L->R/R-.L -
Sets the amount of cross feedback for the delay lines. This controls how much
of the left delay line is fed back to the right and vice-versa.
LEVEL L/R -
Sets the volume level of the delayed signals.
PAN L/R -
Controls the panning of the delayed signals.
LOCUT FREQ -
Sets the cutoff frequency of the lowcut filter. Higher values remove more low
frequency content from the delayed signal.
HICUT FREQ -
Sets the cutoff frequency of the highcut filter. Lower values remove more high
frequency content from the delayed signal.
DRIVE -
Sets the drive level into the tube simulator. This can be used to add some distortion to the
echo like an old tube-based tape delay. This control has no effect when using the Reverse delay
type.
Reverse Delay
TIME -
Sets the time of the delay line (time between echoes).
FEEDBK -
Sets the amount of delay feedback. This controls how many repeats are heard. Use
caution as instability can occur with the reverse type with certain parameter settings.
ECHO PAN -
Controls the placement of the echoes in the stereo image. Note that this is different
than the PAN control on the MIX page which controls the panning of the mixed sound. This control
only effects the wet signal.
RUN -
When this is set to
ON
the reverse playback is active. You can start and stop playback using
this or by attaching a controller to it.
TRIG RESTART -
When this is set to
ON
the reverse playback restarts when triggered via the
RUN
control. If set to
OFF
, the playback continues from the current position.
TEMPO -
Locks the time to the global tempo. For example, if the global tempo is 120 bpm and the
tempo is set to a quarter note (1/4) then the time will be 500 ms (one echo per beat). To ignore the
global tempo set the tempo control to
NONE
.
XFADE TIME -
Sets the crossfade time between reverse audio snippets. When the playback position
approaches the delay time a new snippet begins playback at time zero. The crossfade time controls
how long it takes for the old snippet to fade out and the new one to fade in. You can achieve
interesting and rhythmic variations by setting a long crossfade time. For classic reverse delay
sounds set this at or near its minimum value.
