The Effects
49
FEEDBACK L -
Sets the amount of delay feedback for the left channel. The left feedback control is
the “master” and will automatically set the right feedback to the proper amount so that both
channels decay at the same rate regardless of the ratio. The right channel feedback control can be
used to override this if desired.
FEEDBACK R -
Sets the amount of delay feedback for the right channel.
TEMPO -
Locks the left delay time to the global tempo. For example, if the global tempo is 120
bpm and the tempo is set to a quarter note (1/4) then the time will be 500 ms (one echo per beat).
To ignore the global tempo set the tempo control to
NONE
.
LOCUT FREQ -
Sets the cutoff frequency of the lowcut filter. Higher values remove more low
frequency content from the delayed signal.
HICUT FREQ -
Sets the cutoff frequency of the highcut filter. Lower values remove more high
frequency content from the delayed signal.
DRIVE -
Sets the drive level into the tube simulator. This can be used to add some distortion to the
echo like an old tube-based tape delay. This control has no effect when using the Reverse delay
type.
Ping-Pong Delay
TIME -
Sets the time of the delay lines (time between echoes).
FEEDBK -
Sets the amount of delay feedback. This controls how many repeats are heard.
SPREAD -
Controls the stereo spread of the echoes. Increasing this value increases the separation
between the left and right delay signals.
TEMPO -
Locks the delay time to the global tempo. For example, if the global tempo is 120 bpm
and the tempo is set to a quarter note (1/4) then the time will be 500 ms (one echo per beat). To
ignore the global tempo set the tempo control to
NONE
.
LOCUT FREQ -
Sets the cutoff frequency of the lowcut filter. Higher values remove more low
frequency content from the delayed signal.
HICUT FREQ -
Sets the cutoff frequency of the highcut filter. Lower values remove more high
frequency content from the delayed signal.
DRIVE -
Sets the drive level into the tube simulator. This can be used to add some distortion to the
echo like an old tube-based tape delay. This control has no effect when using the Reverse delay
type.
Dual Delay
TIME L -
Sets the time of the left delay line.
TIME R -
Sets the time of the right delay line.
