Page 8
SAFETY
CONNECTING BELT HAY RAKE
Before each connecting and disconnecting of the belt rake to and from the tractor, lock hydraulic
controls to prevent any unintentional lifting or lowering.
When connecting, pay attention to the category of the tractor and the connecting levers of the
belt rake - they must be adjusted or to match.
There is a risk of injury when connecting the connecting levers.
When using external commands for hydraulics do not stand between the tractor and the belt
rake.
Observe and block the lateral movement of the connecting levers of the tractor during transport.
When driving on public roads with the belt rake in transport position, the tractor hydraulics
commands must be blocked against unintentional lowering.
Do not use the belt rake for work on slopes or transport the belt hay rake by using narrow track
tractors.
SAFETY
USE OF PTO
It is allowed to use only the PTOs that are delivered with the belt rake or recommended by the
manufacturer of the belt rake.
The PTO covers must be installed and be in proper condition and position.
Take care of proper overlapping of tubes in transport and operating position.
Connecting and disconnecting of the PTO can be performed only with the turned off output
cardan shaft of the tractor, turned off engine and ignition keys pulled out.
When attaching the PTO, set the coupling towards the belt rake.
Always properly install cardan shaft.
Secure the PTO covers with the chains against turning.
Summary of Contents for 627 249
Page 20: ...Page 20...
