Page 11
INFORMATION FOR PROPER READING OF THE MANUAL
In this manual “left” and “right” is defined in
terms of the driving direction.
Metric thread is used during installation.
Tighten all screws during installation.
GENERAL INFORMATION
Belt hay rake is designed for collecting of the mowed grass mass (either dried or fresh) and
collecting of the shredded maize after combine harvesting or manual harvesting for further
shredding. The collecting is prior to the operation of baling by high-pressure presses, or a roll baler
or self-loading trailers. This tool can also be used for raking, spreading and turning of the hay to
shorten the drying time.
Due to its good coping it is suitable for use on all types of terrains.
Belt hay rake is the mounting type tool. It is connected to the tractors of 1
st
and 2
nd
category
equipped with 3-point linkage in compliance with ISO 730/I and a six-slot output shaft, diameter
34,9 mm. The tool is lifted during transportation and lowered to the working position by means of
the control levers of the tractor hydraulics.
Belt hay rakes can be aggregated to all tractors manufactured locally or abroad whose engines have
the adequate power at 540 min
-1
of the PTO of the tractor.
The rake is manufactured
as a very
reliable tool that requires minimal maintenance.
The Manual is customized for the basic model of the rake.
It may happen that a part that corresponds
to a functional explanation while the shape slightly differs can be built-in to your rake - in that case,
please do not pay attention to that.
SPECIFICATION OF TECHNICAL CHARACTERISTICS
BELT HAY RAKE TYPE
FPM 627 249/250
Working width
1,6 m/1,9 m
Tractor minimum power output
8,8 KW and more
Maximum work rate
1,6/1,9 ha/h
Number of collecting bodies
9/11
Number of collecting elements
27/33
Transmission
Mechanical
Working height adjustment
mechanical, using the lever on the wheel bearing
Linkage
3 point linkage
PTO (rpm)
540 min
-1
Threads
metric
Weight
190/195 kg
Summary of Contents for 627 249
Page 20: ...Page 20...
