Page 18
Before you start work with the belt hay rake, adjust the belt rake to the height required by the type of
work (Fig. 5).The easiest way to adjust the height is as follows:
1.
Spreading, turning
Switch the belt hay rake from the transport position to the working position so that you lower
it to the ground while connected to the 3-point linkage.
Lower the belt rake so that the collecting elements on the right side touch the flat area and on
the left side they should be lifted for about 8 cm from the ground. Work speed is up to 8 km/h
(see Fig. 5).
For this operation of working with the hay you must take the belts off.
2.
Collecting
Lower the belt hay rake connected to the tractor levers to the ground. Lower it in that position
so that all the collecting springs touch the grass and collect it. Shape the swaths with the belt
which can be regulated (see Fig. 5).
Work speed is up to 6 km/h.
3.
Transport
- Belt hay rake as a transported tool -
Before transport, lift the belt hay rake with the tractor hydraulics to the transport position.
Block the lateral movement of the connecting levers. Tractor hydraulics control must also be
blocked against accidental lowering.
ATTENTION: STOP AND THINK! ROTATING ELEMENTS CAN
CAUSE SERIOUS BODY INJURIES.
DANGER: NEVER
TRY
TO
CLEAN
OR
REMOVE
ANY
MATERIAL FROM THE BELT RAKE AT WORK. TURN
OFF THE TRACTOR AND WAIT FOR THE ROTATING
ELEMENTS TO STOP.
ATTENTION: ENSURE THAT THERE ARE NO OTHER PERSONS IN
THE AREA OF WORK OF THE BELT HAY RAKE AND
ONLY THEN TURN ON THE BELT RAKE AND START
YOUR WORK.
Summary of Contents for 627 249
Page 20: ...Page 20...
