Page 13
SETUP AND MAINTENANCE
ATTENTION: When setting-up the belt
rake, remove all objects.
Foreign objects
and parts may bounce and strike the
persons standing close.
CAUTION: Before performing any work
on the setting-up or regulation of the tool,
turn off cardan shaft and the tractor.
Belt hay rake manufactured by FPM Agromehanika d.o.o Boljevac provides a better quality of work
and has a longer life if properly handled and maintained.
Therefore, observe all the instructions
provided in this Manual to obtain maximum performance and quality of work.
V-BELTS
The endless V-belts should be properly tightened to prevent excessive sliding. Poorly tightened belts
are the cause of the poor performance of the belt rake and early damage and breakage.
Prior to initiation of work, one needs to check the tension of the drive belt (fig. 2 pos. 1), which
should have a deflection of 24 mm when a force of 100 N (10daN) is applied.
Belts bearing the
working elements should have a deflection of 40 mm when applying force of 150 N (15 daN).
Figure 2 Belt hay rake - tightening belts
Summary of Contents for 627 249
Page 20: ...Page 20...
