FPM Agromehanika 627 113C, User Manual And List Of Spare Parts

Page: 14 / 48

14
Fitting is achieved in the following way:
.
1 – Move the tractor backwards, using
hydraulics bring down the lower tractor levers
to the height of the mower linkage point axis
and carry out the fitting and
locking of levers as shown under
A in figure 35.
2 – Upper tractor lever – connect
the coupling (B) with the axle (C)
to the connector on the upper part
of the carrier frame, depending on the
category of tractor turn the thinner or
thicker part of the axle and secure it with
existing tighteners.
3 – Connect the hydraulic tube connector to the appropriate
hydraulic connector on the tractor (one way)
4 – Following that action, using hydraulics
raise the mower off the ground to the
required height for transport.
5 – For safe transport of the mower,
pull out the tightener (A) (figure 36) and
lock the parking switch (B) into the groove (C)
and the mower is ready for transport.
4.2 Cardan joint
It is very important for the Cardan joint to be properly set while con-
necting it to a tractor. Cardan cranks must never be allowed to get
stuck together when the machine is raised into the highest or low-
ered into the lowest position. The Cardan joint has a safety link. Make
sure to place the safety link towards the mower, so that the cutter
can be turned on.
If you determine that the Cardan joint is too long and cannot be con-
nected to the tractor, it is necessary to shorten it. The following im-
ages illustrate the procedure for shortening the Cardan joint.
1 – Join first one, then the other half of the Cardan joint onto the
tractor and the machine, keep one half next to the other, and by
various adjustments of the tractor and the machine, adjust the
length of 10 mm and label it on the protector, (figure 25).
2 – Cut off the protective plastic, see figure 26.
3 – Cut off the profile tube, see figure 27. Further modifications to
the plastic and tube are not permitted.
CAUTION!
THE FOLLOWING ACTIONS AND INSTRUCTIONS MUST BE RESPECTED IN ORDER TO AVOID DAMAGE TO
THE MACHINE AND CARDAN JOINT OR PREMATURE WEARING OF THE CARDAN JOINT. NEVER ATTACH THE CARDAN
JOINT TO THE TRACTOR OUTPUT SHAFT WITH 750 OR 1000 RPM.