FPM Agromehanika 627 113C, User Manual And List Of Spare Parts

Page: 13 / 48

FPM AGROMEHANIKA | 13
4. FITTING THE MOWER
4.1 Fitting onto a tractor
- For the mower to function properly and optimally, the edge of
the cutter bar must be at least 5 cm away from the external edge of
the wheel tract. Figures 32, 33, and 34 show examples of fitting the
mower onto three different types of tractors – for tractors that have
a wheel gap of 1.32m, connect the tractor levers as shown (figure 32).
For a wheel gap of 1.5 m attach the tractor levers according to figure
33. For tractors with a wheel gap of 1.65 m place the tractor levers as
shown in figure 34.
NOTE:
ADJUST THE MOWER SO THAT THE GAP A IS AROUND 5
CM. CHECK THAT THE TENSION CHAIN (C) ALLOWS THE CUTTER
BAR TO TAKE THE APPROPRIATE POSITION FOR OPERATION.
- Make sure to properly tie the awning to the frame while assem-
bling! The awning (D) is tied to a plastic washer (Q), over which a nut
(O) and screw (F) is tied (figure 20). This image shows how to place
the belt with holes (A) and the belt with a loop (B).
- Mount the carrier (J) at the end of the protective frame, fasten it
with two screws (R) (M10x30), two washers (T)(ø 10) and two self-lock-
ing nuts (O) (M10) (figure 17).
- Fasten the additional carrier (S) with a screw (V) (M10x50), and a
screw (R) (M10x45) to the protective frame (see figure 21 and 17).
- Figure 21A shows how to roll the awning into the transport posi-
tion. After rolling the awning, fasten its front and rear part using belts
(A and B) as shown in figure 19, and the mower is ready for transport.
DANGER!
WHEN WORKING WITH THE MOWER, THE
PROTECTIVE CANVAS MUST ALWAYS BE PLACED ONTO
THE FRAME AND LOWERED INTO THE WORKING POSI-
TION.