FPI U32-LP2, Owners & Installation Manual

Page: 9 / 28

9 U32-2 FPI Direct Vent Gas Insert
Logs D)02-46 and E)02-47 in position.
6) Place the Left Top Log D)02-46 on the pin on
Log C)02-56 and on top of the cutout on Log
A)02-43.
7) Place the notch in Center Log E)02-47 over
Log B)02-45 and across the cutout on Log
A)02-43.
Cutout
Pin
Cutout
Notch
8) Position notch in Front Right Log F)02-48 on
Log E)02-47 and push the bottom right edge
against the bracket on the burner tray and
the front edge of the rear burner.
Notch
Bracket
D)02-46
E)02-47
C)02-56
A)02-43
B)02-45
A)02-43
Pins on Rear Log Support
Logs A)02-43, C)02-56,
and B)02-45 in position
A)02-43
B)02-45
C)02-56
3) Place Rear Log A)02-43 on the two pins on
the rear log support.
4) Place Front Right Log B)02-45 on the two
pins as shown.
5) Place the Middle Left Log C)02-56 on the
two pins as shown.
F)02-48
B)02-45
E)02-47
INSTALLATION
LOG SET
INSTALLATION
Read the instructions below carefully
and refer to the diagrams. If logs are
broken do not use the unit until they are
replaced. Broken logs can interfere with
the pilot operation.
The gas log kit contains the following:
a) 02-43 Rear Log 902-227
b) 02-45 Front Right Log 902-229
c) 02-56 Middle Left Log 902-230
d) 02-46 Left Top Log 902-231
e ) 02-47 Center Log 902-232
f) 02-48 Middle Right Log 902-226
g) 02-44 Front Left Log 902-228
h) Embers 902-154
i) Rockwool 902-153
j) Vermiculite 902-179/21
Note: Install Optional Brick Panels prior
to installing logs.
Vermiculite and
embers.
Vermiculite and
embers.
Vermiculite and
embers.
The "02" refer numbers (i.e. 02-43) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite around the firebox
base. Take some of the embers (approx.
1/3 of the bag) and sprinkle over the ver-
miculite.