- 59 -
7. Open the path of the firmware file you just saved, confirm it is correct and click the
Start button.
8. Wait for the firmware upgrade until the firmware upgrade completion dialog box
pops up, then close the firmware upgrade tool and the firmware has been successfully
upgraded.
✜
Please strictly follow the operation steps to ensure that other software using the
port, such as the serial port debugging assistant, all closed , otherwise the upgrade
may fail.
✜
Please select the corresponding firmware, if the firmware does not match, the
upgrade will fail.
12. Common Questions
1.Long press the power switch of the remote control, do not hear
‘
didi
’
sound, and
the power red light only flashing once.
Please confirm if the T30 is powered.
2.The receiver is powered on, but there is no signal output.
Please confirm whether the ID, channel and channel bandwidth of the receiver and the
remote control are set in consistency.
3.Receiver SBUS has signal output, but the serial port is not connected, or the
transmission signal is scrambled.
Please check whether the serial port baud rate of remote control and receiver is
consistent. Set the baud rate of the ground station software.
4.There is interference when two or more devices are started up at the same time
Please check that the ID of each set must be different and the channel must be set
differently to avoid interference of the same frequency.
5.The parameters setting software shows <Remote control port not found>
Verify that the remote-control port number is correct.
13. T30S Remote Controller Parameters
Remote Control
Channel
23 Channel
