1. Connect the power plug.
2. Press the “ ”button, check the light
3. Press the “ ”button, to check if the motor is at normal operation. If there is abnormality,
Please turn off the power immediately, and check if it is the problem of installation.
(Please contact with FOTILE distributor or service center.)
（
1
）
The body of hood shakes heavily.
（
2
）
The expansion pipe is loose.
（
3
）
The impeller doesn’t work.
（
4
）
Big noise from the impeller running.
（
5
）
Abnormal noise from motor.
4. press the “ ”key, the turbine and the light are off
12
11
RANGE HOOD
Debugging
Product Basic Conditions
Main Technical Specifications
Model
EMS9016
Model
EMS9016
1150
220-240V
Frequency
Voltage
50
/
60Hz
IEC Standard
Free Air Exhaust State
Air flow(m
3
/h)
Air flow(m
3
/h)
960
Power
210W
LED Light Power
2W
Noise
（
dB
）
Max Static Pressure
（
Pa
）
49
380
Electric Wiring Diagram
Component Name Diagram
a. Air flow: Deviation between express value and measured value is less than 10% of the
express value.
b. Noise, 49dB is sound pressure level. Weighted sound power level noise is 63dB.
Electrical parameter
Exhaust model (exhaust pipe)
Blue
Yellow and gree
Red
Yellow and gree
L
N
Brown
Blue
Power board
Control panel
Black
Red
Black
Brown
Motor White
Orange
500V
5μF
220V-240
～
/50Hz
Power line Upper gasket
Assembly of air
discharge cover
Electrical box
Volute
assembly
Motor Vane assembly
Air input ring
Tightening screw
Sound-absorbing box
Sound absorbing
cotton of fan cover
Fan cover
Decorative cover
Motor cover
Hook of
decorative cover
Sound absorbing
box of volute
Left fastener
assembly
LED lamp
Ring suction
plate assembly
Oil cup assembly
Oil cup hook assembly
Left hook bracket
Rear plate
Top plate
Fan frame assemble
Pressing line plate
Electric
capacity
Right fastener
assembly
Collection smoke cover
Right hook bracket
Air input cover
Parallel
Switch assembly
(2) Prop the ring suction plate with both hands, make it spiral upward, push in while the
ring suction plate spirals, finally make the touch claw on the ring suction plate insert into
he touch button on the smoke collection hood;
10. Install anti-collision accessories, firstly remove the double faced adhesive tape (see Figure 3),
then stick the anti-collision accessories to the corner of the smoke exhaust (see Figure 4);
11. Install the oil cup assemblies(see Figure 5);
12. Insert the host power plug into the power outlet.
895mm
525mm
335.5mm
395mm
990mm(max)
595mm(min)
80mm
