FOTILE EMS6008, Operation And Installation Manual

Page: 33 / 34

- 28 - - 29 -
2) Install the carbon filter;
3) Finally, install the removed front filter in the original position.
14. Install the wing plate;
1) Remove the protective film from the wing plate;
2) Hold the front side of the wing plate tightly in both hands, and put the left and right hook on the
rear side of the wing plate into the hook frame at the bottom of the exhaust fume collecting hood;
3) Hold the wing plate with both hands to rotate it upward, and then clamp the locking tab of the wing
plate into the bump buckle on the exhaust fume collecting hood.
Notes:1.Failure to install all the parts (e.g. wing plate) in accordance with these
instruction, may result fire hazard.
2.If it takes much effort to clip the locking tab of the wing plate into the buckle on
the exhaust fume collecting hood, please refer to Point 13 of “Precautions for
Installation” in P17 to check the status of installation surface for the range hood
and operate according to the instructions.
Commissioning after Installation
1. Press the power/delay button, then press the high-speed /turbo button to check whether the
motor rotates normally. In case of the following abnormal conditions, cut off the power supply
immediately, stop the operation, and check whether this is due to installation
(1) The body vibrates violently (2) The blades not rotate
(3) There is an obvious friction sound when the blades rotate (4) The motor makes an abnormal
2. Check whether all buttons are functioning normally according to the operation instructions.
(If it is determined that the range hood is faulty, please call the Fotile authorized service center)
Explosive View
Rear
plate
Fan
frame
Wire
hole
sleeve
Decorative
cover hook
(only forEMS6008-C)
Volute
housing
Exhaust
hood
Motor Motor
screw
Power
board Impeller
Intake
ring
Retractable
screw
Sound
absorption
box
Electric
box
Fan
cover
Decorative hood
(only for EMS6008-C)
Top
plate
Bump
buckle
Wing
plate hook
Wing
plate
Panel
Cleaning the
Front filter
Control
board
Connecting
bracket
LED
lamp
Exhaust fume
collecting hood
Cushion
Fan cover
(only for EMS6008-C)
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
Correct Disposal of this product